62 FL Chop Rebuild 6
Looking for handlebar controls for the front disk brake and the clutch.
Have these controls on hand, the round reservoir one is for a Honda cb750.
The Unibit in the middle of this pic is a 1" piece
for boring out the two Honda units on the bottom from
7/8" to 1".
I like the looks of these two pieces the best...
The handlebar clamp for the Honda MC has a lot of meat for boring it out to 1"
The clutch handlebar clamp does not have much meat on it, possibly I could offset bore it
toward the clutch handle pivot, keep the outer half of the clamp as thick as possible....
I'm more inclined to use the top clutch control above and paint it black where it needs it to match the Honda MC.
It's beefy and is already 1", so no boring needed !
That unit has a switch on it though, and I don't know what that is for, I don't see a need for it....
So this is the combo I would be using, with some black on the clutch control....
I don't like that handle on the master cylinder....
I think I'll see if this handle off one of the other MC's would work....
This piece is a hydraulic actuated switch for the master cylinder, to operate the brake lites....
Let's see how all this turns out....
A severe injury has slowed things down,
but I hope to be back up and working on this soon....
more later....
